Deleting A Single Learning Key; Deleting All Learned Keys In A Specific Mode - MTS ATLAS Guide D'utilisation

Continue holding the key on the original
remote until the Atlas DVR/PVR IR/UHF
Remote's LED blinks twice.
NOTE: If the LED displays one long blink, a learning
error has occurred. Try repeating this step
again until a successful capture occurs. If the
function is still not captured, press and hold
SETUP to exit programming and review the
"Learning Precautions" on the previous page.
If needed, also see "Troubleshooting" on
page 23. After review, start programming
again at step 1.
5. Repeat steps 2 through 4 for another mode
and/or key or press and hold SETUP to exit
programming.

Deleting a Single Learning Key

This process returns the key to its original programming
for the mode you select. You can also delete learned
programming by teaching a different function to the key
(see "Programming a Learned Key" on page 13)
NOTE: If more than 15 seconds pass between key
presses, the remote exits programming.
Press and hold SETUP until the last-selected
1.
mode key blinks twice, then press 9 7 6.
2. Press a mode key once (i.e., MTS, TV, DVD,
AUD, or AUX).
3. Press the key containing the learned function
to be deleted twice. The mode key blinks
twice and exits from programming.

Deleting All Learned Keys in a Specific Mode

NOTE:
If more than 15 seconds pass between key
presses, the remote exits programming.
Press and hold SETUP until the last-selected
1.
mode key blinks twice, then press 9 7 6.
2. Press a mode key twice (i.e., MTS, TV, DVD,
AUD, or AUX) to clear all the learned keys for
that mode. The mode key blinks twice and
exits from programming.
14