Using The Master Power Key; Clearing The Master Power Key; Re-Assigning Device Keys - MTS ATLAS Guide D'utilisation

Using the Master Power Key

1. After programming, point the remote control
at the devices and press and hold PWR for 1.5
seconds.
You see the devices turn on or off according to the
programmed sequence.

Clearing the Master Power Key

On the remote control, press and hold SETUP
1.
until the last-selected device key blinks twice.
Enter 9 9 5. The last-selected device key
2.
blinks twice.
Press PWR. The last-selected device key blinks
3.
twice and the remote exits from
programming.

RE-ASSIGNING DEVICE KEYS

The Atlas DVR/PVR IR/UHF Remote can be set up to
control a second device of an already-assigned type. For
example, to have the unit control a TV, a set-top box, and
two DVD players, re-assign the unused AUX key to
operate the second DVD Player as follows:
NOTE: AUX is preset at the factory to control an RCA
VCR. Performing the steps below overwrites
those settings.
On the remote control, press AUX once; it
1.
blinks once. Then press and hold SETUP until
the AUX key blinks twice.
2. Enter 9 9 2. The AUX key blinks twice.
3. Press DVD once, then press AUX once. The AUX
key blinks twice.
The AUX key is now ready to be programmed for your
second DVD player. See "Programming Device Control"
on page 9. To re-assign other device keys, repeat these
and substitute the key sequence using the following
chart:
18