Programming Channel Control Lock; Unlocking Channel Control; Locking Channel Control To Mts; Changing Volume Lock - MTS ATLAS Guide D'utilisation

PROGRAMMING CHANNEL CONTROL LOCK

By default, the remote control's channel-control
capabilities are locked to the set-top box. The affected
*
keys are 1 through 0, CH+, CH-, ENTER, and LAST. This
guarantees that you do not inadvertently change a
channel on your TV or VCR. However, you can de-
activate this feature to allow full access to these keys in
the TV and VCR modes.
*
NOTE: This feature does not affect the AUD mode.

Unlocking Channel Control

1. On the remote control, press MTS once; it
blinks once. Press and hold SETUP until the
MTS key blinks twice.
Enter 9 7 3. The MTS key blinks twice.
2.
3. Press CH- once. The MTS key blinks four
times.
Now the remote control provides TV and VCR channel-
control capabilities while in the TV or VCR mode.

Locking Channel Control to MTS

On the remote control, press MTS once; it
1.
blinks once. Press and hold SETUP until the
MTS key blinks twice.
2. Enter 9 7 3.The MTS key blinks twice.
Press CH+ once. The MTS key blinks twice.
3.
Now, regardless of what mode you select (except AUD),
the channel keys only change channels on your set-top
box.

CHANGING VOLUME LOCK

Volume Lock allows you to control the volume through
the device identified as having your primary speaker(s),
regardless of which mode you are using. On theAtlas
DVR/PVR IR/UHF Remote, Global Volume Lock is set to
15