Controls - see Fig. 2
The main ON/OFF switch must first be turned ON to operate any
of the other controls.
Setting
Operation
Flame effect
Press 'I' button once
Flame effect & 1kW heat
Press 'I' button again
Flame effect & 2kW heat
Press 'I' button again
To turn off any settings
Press 'O' button again
Remote control - see Fig. 5
The maximum range of use is ~ 15metres. For details on the
function please refer to the 'Controls' section in this instruction
leaflet.
Warning: It takes time for the receiver to respond to the
transmitter.
Do not press the buttons more than once within two seconds
for correct operation.
Battery information - see Fig. 5
1.
Slide open the battery cover on the back of the remote
control.
2.
Install AAA batteries into the remote control.
3.
Replace the battery cover.
Discard leaky batteries
Dispose of batteries in the proper manner according to provincial
and local regulations.
Any battery may leak electrolyte if mixed with a different battery
type, if inserted incorrectly, if all the batteries are not replaced at
the same time, if disposed of in a fire, or if an attempt is made
to charge a battery not intended to be recharged.
Thermal Safety Cut-out
A thermal safety cut-out is incorporated in the heater to prevent
damage due to overheating. This can happen if the heat outlet
was restricted in any way. The heater will switch on once the
obstruction has been removed and the heater has cooled. If the
cut-out continues to operate intermittently, the heater should be
switched off and a service agent contacted.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE ATTEMPTING ANY MAINTENANCE.
Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) bulbs in place
of conventional bulbs. These generate the same light levels as
conventional bulbs, but use a fraction of the energy consumed.
Indication
These LED bulbs are maintenance-free and will not require
Bottom neon
replacing during the life of the product.
Bottom & middle neon
All 3 neons
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE HEATER.
For general cleaning use a soft clean duster – never use abrasive
cleaners. The glass viewing screen should be cleaned carefully
with a soft cloth. DO NOT use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush
attachment of a vacuum cleaner should occasionally be used
to clean the outlet grille of the fan heater.
Recycling
For electrical products sold within the European
Community.
At the end of the electrical products useful life it should
not be disposed of with household waste. Please
recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice in your country.
After Sales Service
Should you require after sales service you should you need to
purchase any spares, please contact the retailer from whom the
appliance was purchased or contact the service number relevent
for your country on your warrenty card.
Please do not return a faulty product to us in the first instance
as this may result in loss or damage and delay in providing you
with a satisfactory service.
Please retain your receipt as proof of purchase.