Installation Instructions; Choosing The Right Location; Connection To Power Supply - Danby Designer DUFM026B1WDD Guide D'utilisation Et Soins De Propriètaire

Remove exterior and interior packagings, wipe the outside thoroughly with a soft dry cloth and the inside with a wet, lukewarm
cloth. Avoid placing the unit in a narrow recess or near any heat source, direct sunlight, or moisture. Let air circulate freely
around the unit. Keep the rear of the freezer 2 inches away from the wall.
CHOOSING THE RIGHT LOCATION
1) Select a place with a strong, level floor.
2) Allow 2 inches of space between the back of the freezer
and any adjacent wall.
3) Avoid direct sunlight and heat. Direct sunlight may affect
the acrylic coating. Heat sources nearby will cause higher
electricity consumption.
4) Avoid very moist places. Too much moisture in the air will
cause frost to form very quickly on the evaporator, and
your freezer will have to be defrosted more frequently.
INSTALLATION
Place the appliance firmly on a solid base. Some appliances
have adjustable feet on the front side; use them to level the
appliance.
NOTES:
• This appliance is intended for FREE-STANDING INSTAL-
LATION ONLY, and is NOT intended to be built-in.
• Before connecting this appliance to electrical power sup-
ply, leave it to stand for approx. 24 hours, which will
reduce the possibility of malfunction in the cooling sys-
tem due to transport handling.
• This appliance is approved for INDOOR USE ONLY and
is NOT intended for outdoor operation.
INSTALLATION INSTRUCTIONS
CONNECTION TO POWER
SUPPLY
Connect the appliance power cord to a properly grounded
wall outlet. The required nominal voltage and frequency are
indicated on the rating plate (inside the unit or on the exterior
rear wall of the unit.)
3