C Hanging The Power Cable; H Ow Do You Change The Bulb - Fagor 5H-730 Serie Guide D'utilisation

Masquer les pouces Voir aussi pour 5H-730 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

99639111_A_ML.qxp
02/03/2006
C
hanging the power cable
• The power cable (H05 RR-F, H05 RN-F or H05 VV-F) must be of sufficient length to
be connected to the build-in oven while it sits on the floor in front of the cabinet.
To do this the appliance must be disconnected from the electrical network:
• Open the inspection flap located at the lower right of the back cover by unscrewing
the two screws, then pivot the inspection flap.
• Strip 12 mm along each wire of the new power cable.
• Carefully twist together the strands.
• Loosen the screws from the terminal board and remove the power cord to be
replaced.
• Introduce the power cable through the side of the cover in the cable clip located to
the right of the terminal board.
• Connect the power cord wires in accordance with the written markings on the terminal
board.
• All the strands of the electricity wires must be captured under the screws.
• The phase wire on the L terminal.
• The green-yellow coloured ground wire should be connected to the
• The neutral conductor (blue) on the N terminal.
• Screw down tightly the screws on the terminal board and check the connection by
pulling on each wire.
• Attach the cable with the cable clip located to the right of the terminal board.
• Close the inspection flap using the two screws.
We cannot be held liable for any accident resulting from an
inexistent, defective or incorrect ground lead.
H
ow do you change the bulb?
• The bulb is located on the ceiling of your oven's cavity.
Disconnect your oven before performing any task on the bulb to avoid
the risk of electric shock and, if necessary, let the appliance cool down.
a) Unscrew the view port (see
adjacent diagram).
b) Unscrew the light bulb in the
same direction.
Bulb specifications:
- 15 W
- 220-240 V
- 300°C
- E 14 cap
c) Replace the bulb then reposition
the view port and reconnect your oven.
To unscrew the view port and the light, use a rubber glove, which
will make disassembly easier.
8
16:50
Page 8
How do you install your oven?
Bulb
Unscrew
terminal.
View port

Publicité

Chapitres

Table des Matières
loading

Table des Matières