Taurus ULTIMATE GO Mode D'emploi page 8

ENGLISH
Appliance Type
Ultimate go
Ultimate digital
Ultimate go animal
Ultimate digital fuzzy
DESCRIPTION
A Accesories:
A1 Lance and multiuse brush
A3 Extralong lance
A4 Small Turbo brush (*)
B Extension tube
C Motorized turbobrush
D Motorized turbobrush Fuzzy (**)
E Filter
F Battery indicator
G ON/OFF button
H Body
I Dust tank
J Lithium batteries
K Wall bracket
L Power supply
(*) Only available in the model Ultimate Go
Animal
(**) Only available in the model Ultimate Digital
Fuzzy
If the model of your appliance does not have the
accessories described above, they can also be
bought separately from the Technical Assistance
Service.
USE AND CARE:
- Do not use the appliance without its filter(s)
correctly in place.
- Do not use the appliance if its accessories are
not properly fitted.
- Do not use the appliance to gather up water or
any other liquid.
- Do not use the appliance if the on/off switch
does not work.
- Store this appliance out of reach of children
and/or persons with physical, sensory or
reduced mental or lack of experience and
knowledge.
- Do not work on areas where there are metal
objects, such as nails and/or screws.
- Never vacuum hot or sharp objects (cigarette
butts, ashes, nails, etc.).
- Do not open the battery/ies under any circum-
stances whatsoever.
- The battery/ies should be stored at a tempera-
ture of below 40ºC.
- Only use the appliance for carrying out dry
tasks.
- Do not use the appliance on any part of the
body of a person or animal.
- Recharge the battery/ies only with the charger
supplied by the manufacturer. A charger that
is suitable for one type of battery may cause
explosion or fire hazard when used with other
battery/ies.
- Use the device only with the battery/ies for
which has been specifically designed. The use
of any other battery/ies s can cause an explo-
sion or fire hazard.
INSTALLATION
- Be sure to remove all packaging material from
inside the appliance.
ASSEMBLING THE WALL BRACKET:
- The appliance has a wall bracket (K) which
must be fixed to the wall.
- Fix the wall bracket as you think appropriate,
using plugs, screws, and adhesive...
- Make sure that the bracket is firmly fixed; it
should be able to support twice the weight of
the appliance.
- Fit the appliance into the wall support.
CHARGING THE BATTERY
- Caution: A new battery is not fully charged and
must therefore be charged before the appli-
ance is used for the first time.
- Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
- Plug the charger (L) into the mains.
- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 4 to 5 hours are needed for a