Safe Battery Care Information; Replacing The Batteries - CMF SpinaLogic Manuel

Safe Battery Care Information

Do not do any of the following:
• Never heat or throw the batteries in a fire .
• Never charge the batteries .
• Never let the battery ends contact each other or other metal . Do not let
a piece of metal touch both ends of a battery at the same time .
• Never damage or use damaged batteries .
• Never use batteries other than in their correct position .
• Always keep batteries at room temperature, about 70°F (20°C) in less
than 80% relative humidity and out of direct sunlight .
• Use ONLY the batteries supplied in the carrying case with SpinaLogic
• Remove primary batteries when equipment is not likely to be used for
some time to avoid battery leakage .
• The batteries may be replaced only after the display turns off .
NOTE: Be sure to remove plastic from batteries before replacing them.

Replacing the Batteries

WARNING: Battery operated device (9V alkaline battery), not to use
lithium batteries .
The LCD screen will show the following icon when it is time for new
batteries . This picture will be shown at the start of a treatment or during
treatment . The device will turn off after this picture is displayed .
Never change the batteries when the device is running.
Wait until the device stops operating to change the battery.
The picture in Figure 4, below, shows the correct way to replace the
battery . When replacing the battery, you will see the correct way to put
them in on the inside of the battery compartment . Use ONLY the
batteries supplied with SpinaLogic . They are located in the carrying case .
Figure 4 . Battery Compartment
EN
®
.
9