Sony KP-51WS500 Mode D'emploi page 39

2-12-3.OPERATION METHOD FOR
PROJECTOR ENGINE MODE
MUTING
Category up
Adjustment
item up
Adjustment
item down
Category
down
Initialize data
(Not stored)
MENU
Data Up/
Down
VOLUME +
RM-Y909
1. FUNCTION OF KEYS ON COMMANDER
1
Changes adjustment item. (Item # moves up)
Marker moves clockwise from center to outside.
(In Fine Adjustment mode)
4
Changes adjustment item. (Item # moves down)
Marker moves counter clockwise from outside to center.
(In Fine Adjustment mode)
2
Changes adjustment category.
(Category # moves up)
5
Changes adjustment category.
(Category # moves down)
Joystick Changes data value. (Up or down)
Marker moves clockwise from center
(up, down, right, and then left) to outside.
(In Fine Adjustment mode)
3
Changes adjustment color.
GRN BLU RED
6
Displays or changes internal test signals.
crosshatch + external signal
crosshatch + borderline
crosshatch only
dot only off
9
Switches adjustment mode.
Coarse adjustment model
Fine adjustment mode
POWER
DISPLAY
Color Select GRN
to BLU to RED
Internal Test signal
Mode Select
(Course Adjustment
Fine Adjustment)
ENTER
— 39 —
Press Switches marker moving method.
Joystick (In Fine Adjustment mode)
Joystick keys
5 6 3 4
Commander Function
Buttons Mode
0 + ENTER READ
MUTING+ENTER WRITE
7 + ENTER PJE
INITIAL
2. OPERATION METHOD FOR COARSE ADJUSTMENT
1. Enter the service mode and select "PJE".
2. Press the "1" or "4" button on the remote commander to select the
item, and then use the joystick to change the data.
Item No.
PJE 00
FDIS
Adjustment Item
3. Select "GRN CENT". When BLU or RED is displayed, press the "3"
button on the remote commander to change the adjustment color
in the order of GRN BLU
4. In GRN, BLU, or RED mode, move the joystick 5 or 6to change
the data in vertical direction, or 3 or 4 to change the data in a
horizontal direction.
Data (H)
Color
GRN 000
CENT
Adjustment Item
5. Before returning to the service mode, press the "MUTING" +
"ENTER" buttons on the remote commander to write the data.
(You must complete step 5 to write the data. If you omit step 5 the
set data is returned to the data prior to the adjustment.)
3. OPERATION METHOD FOR FINE ADJUSTMENT
1. Enter the service mode and select "PJE".
2. Select FDIS and set the data to "01" so that the data at each
position can be displayed in fi ne adjustment mode.
KP-51WS500/57WS500/65WS500
1 and 4 buttons
Description
Reads data to NVM.
Writes data from NVM.
Service data initialization.
Not stored.
(Be sure not to use usually)
Data
00
Joystick
54 direction:Data up
63
direction:Data down
RED.
Data (V)
000
3
: Data (H) up
4
: Data (H) down
5
: Data (V) up
6
: Data (V) down