Monthly Cleaning - Rex-royal S500 Mode D'emploi

Masquer les pouces Voir aussi pour S500:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Drinks outlet without milk module
1.
The machine must be switched-off.
2.
Remove the outlet cover (P .1).
3.
Remove the coffee outlet (P .2).
4.
Clean all parts thoroughly. Clean the nozzles with the special
brush.
5.
Put the drinks outlet in reverse order, together again.
Intensive cleaning powder module
1.
The machine must be switched-off. Open the front door.
2.
Unlock and remove the cover before deposit powder hoppers.
3.
Close the powder injection and clean the powder tubes.
4.
Remove the powder hoppers (lift off top).
5.
Turn the yellow ring of the mixer cup against the watch hand.
6.
Remove and seperate the mixer cup ring and the mixer cup.
7.
Remove the black mixer rotor.
8.
Unlatch and open the black cover flap.
9.
Remove the foam filter.
10.
Clean all parts thoroughly and wait until they are dried.
11.
Put the parts in reverse order, together again.
12.
ATTENTION:
The mixer rotor must fit exactly on the notch of the motor shaft.

MONTHLY CLEANING

Cleaning the bean hoppers
The cleaning should be accomplished 1x monthly. Use a degreasing
cleaner and a brush.
1.
The machine must be switched-off.
2.
Pull the closure, at the foot of the bean hopper, so far as pos-
sible.
3.
The hoppers can now be lifted up and removed from the top of
the coffee machine.
4.
Empty coffee beans temporarily in another container.
5.
The interior of the bean hoppers should be cleaned thoroughly
with grease-busting detergent and a brush.
6.
After drying move back the coffee beans.
7.
Put the bean hoppers in reverse order, together again.
Cleaning the powder hoppers
1.
The machine must be switched-off.
2.
Open the front door of the powder module.
3.
Unlock and remove the cover before deposit powder hoppers.
4.
Close the yellow powder injection. Remove the powder hoppers
(lift off top).
5.
Empty powder temporarily in another container.
6.
Clean the powder hoppers inside and outside thoroughly.
7.
After drying move back the powder.
8.
Put the powder hoppers in reverse order, together again.
64
P .2
P .1
B
A
P .1
S500 - Operating Instructions
S500 - Operating Instructions
B
A

Publicité

Table des Matières
loading

Table des Matières