Options And Accessories - Hatco HBG Serie Manuel D'installation Et D'utilisation

OPTIONS AND ACCESSORIES

Remote Mounted Control Panel
(HBGB Model)
A flush-style remote mounted control panel is available as a
factory-installed option for the HBGB unit. Install the control
panel on-site using the following procedure.
WARNING
ELECTRIC SHOCk HAzARD: Remote mounted control
panel must be mounted on a vertical wall and installed in
vertical position. Mounting control panel in horizontal
position may result in collection of liquids and lead to an
electric shock.
NOTICE
The remote mounted control panel should be installed
outside of the heat zone. Locating the control panel inside
the heat zone will cause the control(s) to overheat,
malfunction, and fail.
Do not modify wiring or cut thermostat capillary wire on
control box to increase semi-remote mounting distance.
Cutting the thermostat capillary wire will cause the unit to
overheat and may damage the unit as well as the
surrounding countertop.
NOTE: A qualified electrician is recommended for installing the
remote mounted control panel.
1. Prepare cutout and pre-drill screw holes (see Figure 10).
2. Remove trim cover from control panel assembly.
3. Position control panel into opening through the backside.
4. Secure control panel
(not supplied).
5. Plug the control panel into a properly grounded electrical
outlet of the correct voltage, size, and plug configuration.
Refer to the SPECIFICATIONS section for details.
6. Reinstall trim cover.
NOTE: Units are equipped with a 914 mm (36") flexible conduit
connecting the control panel to the unit.
121 mm
(4-3/4")
to surface using screws
A
D
C
Figure 10. Remote Mounted Control Panel Installation Dimensions
Power ON/OFF Switch
The remote mounted control panel is equipped with a power
ON/OFF switch. Move the power ON/OFF switch to the ON
position to turn on the unit. The indicator light in the switch glows
when the unit is on.
Adjusting the Temperature Control
Turn the temperature control clockwise to increase the
temperature setpoint.
counterclockwise to decrease the temperature setpoint.
Temperature
Control
Power ON/OFF Switch
Figure 11. Remote Mounted Control Panel
Cutout
Dimension
149 mm
B
(5-7/8")
162 mm
(6-3/8")
12
Turn the temperature
Screw Hole
Dimension
(A) (C)
98 mm
(3-7/8")
(B) (D)
171 mm
(6-3/4")
Form No. HBGCEM-1110
control