Options And Accessories - Hatco GLO-RAY GRSS Série Instructions Originales

OPTIONS AND ACCESSORIES

102 mm (4") Adjustable Legs
(GRSS Models only)
Use the following procedure to install 102 mm (4") adjustable
legs in place of the rubber feet on a GRSS unit.
NOTE: 102 mm (4") legs are included with models greater than
914 mm (36") in width.
WARNING
ELECTRIC SHOCK HAzARD: Turn OFF power switch,
unplug power cord, and allow unit to cool before
performing any cleaning, adjustments, or maintenance.
NOTICE
Do not lay unit on the side with the control panel. Damage
to unit could occur.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Carefully turn the unit upside down and lay the unit on a
flat surface. Make sure to cover the surface with something
to prevent scratching the glass.
3. at each corner of the base, remove the foot screw and
rubber foot.
Installing the 102 mm (4") Legs
4. at each corner of the base, screw a 102 mm (4") leg
through the bottom of the base.
NOTE: The feet on the 102 mm (4") legs are adjustable for
leveling the unit. Use a 16 mm (5/8") open-end wrench
to make leveling adjustments once the unit is placed in
its final position.
102 mm (4") Leg
Handles (GRSS Models only)
Designer black powdercoated rounded stainless steel handles
are available for GRSS models.
The handles are field retrofittable and are installed onto each
end of the unit using the following procedure.
On each end of the unit:
1. Remove the three nuts located on the underside of the
stone surface support ring.
2. align the three holes on the handle with the three studs on
the support ring, and position the handle on the studs.
3. Replace the three nuts onto the studs, and tighten securely.
Handle
Handle Installation
Recessed Top for GRSSB Models
an optional recessed top is available for GRSSB models. Units
with a recessed top allows the heated surface to sit lower than
countertop surface.
14
Support
Ring
Stud
Nut
Form No. GRSSCEM1-0715