Hatco HBG Serie Manuel D'installation Et D'utilisation page 13

102 mm Adjustable Legs (HBG Model)
Use the following procedure to install 102 mm (4") adjustable
legs in place of the rubber feet on an HBG unit.
NOTE: 102 mm (4") legs are included with models greater than
1041 mm (36") in width.
WARNING
ELECTRIC SHOCk HAzARD: Turn OFF power switch,
unplug power cord, and allow unit to cool before
performing any cleaning, setup, or maintenance.
NOTICE
Do not lay unit on the side with the control panel or
damage to unit could occur.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Carefully turn the unit upside down and lay the unit on a flat
surface. Make sure to cover the surface with something to
prevent scratching the glass.
3. Remove and save the base screws that secure the base to
the glass shelf assembly. There are ten screws — two at
the control panel and eight around the sides of the unit.
Glass Shelf
Assembly
Figure 12. Removing the Base
4. Lift the base off of the glass shelf assembly.
5. At each corner of the base, remove the foot screw and
shoulder washer to remove the rubber foot.
Rubber Foot
Shoulder
Washer
Foot Screw
Figure 13. Installing the 102 mm Legs
6. At each corner of the base, insert a 4" leg through the
bottom of the base. Place a nut on the leg stem inside the
base and tighten securely.
7. Reassemble the base to the glass shelf assembly.
NOTE: The feet on the 102 mm legs are adjustable for leveling
the unit. Use an adjustable wrench to make leveling
adjustments once the unit is placed in its final position.
Form No. HBGCEM-1110
Base
Base Screw
102 mm Leg
Nut
OPTIONS AND ACCESSORIES
Handles (HBG Model)
The following handles are available for the HBG unit.
HANDLE-18-SS ....Rounded stainless steel handles
HANDLE-18-BLk ..Designer black powdercoated rounded
stainless steel handles
The handles are field retrofittable and are installed onto each
end of the unit using the following procedure.
On each end of the unit:
1. Remove the three nuts located on the underside of the
glass surface support ring.
2. Align the three holes on the handle with the three studs on
the support ring, and position the handle on the studs.
3. Replace the three nuts onto the studs, and tighten securely.
Handle
Figure 14. Handle Installation
13
Support
Ring
Stud
Nut