Lindy 38343 Manuel Utilisateur page 8

User Manual English
Receiver Front and Rear
Power LED: Indicates Power.
ARC LED: This will illuminate green when the ARC function has been switched on.
SPDIF LED: This will illuminate green when the TosLink Out port outputs the audio signal which has been
sent from the TosLink In connection of the receiver.
USB: Connect to a mouse, keyboard or other USB devices.
Push Button switch: Push the button to switch the output audio source, for TosLink Out and 3.5mm Out.
Service: Reserved for future use.
24V DC: Connect the 24VDC 1A PSU to an AC wall outlet and securely connect to the transmitter or
receiver. This is only required at one side of the installation.
HDBaseT In: HDBaseT Input Port. Connect a compatible HDBaseT transmitter using a single Cat.6 or
above cable for all data signals. Please do not connect to a network port.
HDMI Out: Connect to an HDMI display.
IR In: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used is
within the direct line-of-sight of the IR Extender.
IR Out: Connect the supplied IR Transmitter Cable for IR signal transmission. Place the IR Transmitter in
direct line-of-sight of the equipment to be controlled.
TosLink In: Connect to a digital audio source with a TosLink (Optical) cable.
RS-232: Connect to a PC, Serial Controller or Serial device via phoenix block 3-way connection for the
pass-through transmission of RS-232 commands.
Ethernet: Connect to a PC or laptop.