Installing Briquettes, Grates, And Rotisserie - Newage 65901 Manuel D'installation Et D'utilisation

Propane Cylinder Installation
WARNING!
• Never connect a gas line directly to the grill. A pressure regulator must
be installed on all gas equipment. All local codes require it and NEWAGE
!
supplies the correct regulator with your grill. Removing or failing to install
the pressure regulator can result in fire and serious personal injury and will
void the warranty
• Do not change the regulator/hose assembly or use any other assembly than
the one supplied with your NEWAGE grill.
• Do not store a spare LP-gas cylinder under or near this appliance.
• Never fill the cylinder beyond 80 percent full.
1
Remove the grease tray.
Attach type 1 regulator hand wheel to the
3
tank. Clockwise to tighten, counter clockwise
to loosen.
14
www.newageproducts.com
Remove pre installed Natural Gas Hose and
2
replace with Propane / regulator assembly.
WARNING! The grill and cabinet must have
! a minimum clearance from combustible
5
materials. Refer to below figure for
dimensions.
3
* The outdoor cooking gas appliance
shall not be used under overhead
combusible construction
Side - 10" Clearance
Rear - 18" Clearance
18 Inches
10 Inches
Installing Briquettes, Grill Grates and Rotisserie
1 Install the three briquette trays as shown below.
Install the warming rack, making sure that the
3
longest grate rod gets inserted into slots in
support shelves. Figure (A).
3
A
Slide the rotisserie motor down onto the
5
mount clips on side of grill.
www.newageproducts.com
Install the grill grates as shown.
2
Assemble the rotisserie by sliding the forks
and hand tighten the finger bolts. Slide the
4
counterweight and end piece on and hand
tighten.
Insert the squared end fully into the hole
6
on the motor mount. Drop the notched end cap
of the skewer onto the rollers, (B).
3
B
15