Makita DTW1001 Manuel D'instructions page 9

NOTE: If the drill bit is not inserted deep enough into
the sleeve, the sleeve will not return to its original
position and the drill bit will not be secured. In this
case, try re-inserting the drill bit according to the
instructions above.
NOTE:
Ring
Only for Model DTW800
Fig.13: 1. Bracket 2. Ring 3. Screws
tool up to the air with hoist.
CAUTION:
Before using the ring, always
make sure that the bracket and ring are secured
and not damaged.
Installing hook
Fig.14: 1. Groove 2. Hook 3. Screw
the hook, insert it into a groove in the tool housing
remove, loosen the screws and then take it out.
OPERATION
CAUTION:
Always insert the battery cartridge
all the way until it locks in place. If you can see
the red part on the upper side of the button, it is not
locked completely. Insert it fully until the red part can-
not be seen. If not, it may accidentally fall out of the
Fig.15
fastening time.
the kind or size of the bolt, the material of the workpiece
Model DTW1001
Proper fastening torque for standard bolt
2
N•m
(kgf•cm)
800
(8160)
600
(6120)
400
(4080)
200
(2040)
0
0
1. Fastening time (second) 2. Fastening torque
Proper fastening torque for high tensile bolt
2
N•m
(kgf•cm)
800
(8160)
600
(6120)
400
(4080)
200
(2040)
0
0 1
1. Fastening time (second) 2. Fastening torque
9 ENGLISH
M30(1-1/4")
M30(1-1/4")
M24(1")
M24(1")
1 2 3
1
M24(1")
M22(7/8")
M20(3/4")
2 3 4 5
1
M24(1")
M22(7/8")
M20(3/4")
6