Prepare An Espresso - CONTINENTAL EDISON CEME20BI Guide D'utilisation

B. PREPARE AN ESPRESSO
1.
Remove the percolator (D) by turning it clockwise.
2.
Put a coffee filter in the metal filter holder, make sure it is aligned with the
groove of the filter holder so that it can be inserted.
3.
- If you are using ground coffee, add it to the ground coffee filter (E) using the
measuring spoon, then press firmly on the coffee with the buffer.
- If you are using a suitable compact pod, replace the stainless-steel filter
for ground coffee with the stainless-steel filter for compact pod (F).
- If you are using a capsule, use the percolator (R) with the capsule filter (Q).
4.
Insert the percolator into the appliance and secure it firmly by turning it
counterclockwise until it is in the "Lock" position.
5.
Place 1 or 2 cups under the percolator then select a single or double espresso.
To choose the desired amount of coffee, press the 1 cup button once
cups
button again to stop it.
Note : Memorization of the flow time for 1 cup and 2 cups
When the device is turned on, you can change the flow time
as following :
• After preheating, hold the 1 cup button
about 3 sec. until the pump starts.
• When the desired amount of espresso is reached, press again.
the 1 cup or 2 cup button to stop the espresso flow.
If you turn off the device and restart it, the change will be saved.
6.
When the preparation is finished, you can remove the percolator by turning it
clockwise, then pour the coffee grounds with the steel sieve into your sink or
a waste container and then rinse them under cold water.
. When the desired quantity of coffee is reached, press the same
EN-15
or 2
or 2 cups