Keurig Platinum B70 Guide D'utilisation Et D'entretien page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Keurig_CareGuide_spreadsB70
Ready to Brew Your First Cup
K-Cup
®
Handle
portion pack
K-Cup
Chamber
1. LCD Control Center will indicate 'READY TO
BREW'.
2. Place a cup or mug on the Drip Tray Plate.
3. Lift the Handle and the K-Cup chamber will
open toward you.
CAUTION: There are two sharp needles that
puncture the K-Cup
the K-Cup Holder and the other in the bottom
of the K-Cup Holder. To avoid risk of injury,
do not put your fingers in the K-Cup Chamber.
4. Select a K-Cup
NOTE: Do not remove the foil lid or
puncture the K-Cup
5. Place a K-Cup
Holder (as shown in exhibit at top of page).
6. Lower the Handle to close the Lid over the
K-Cup Holder. (When it is closed complete-
ly, the LCD Control Center will indicate
'READY TO BREW'. The 'LEFT' and 'RIGHT'
Buttons will be lit and the 'BREW' Button
will flash up to 60 seconds.)
a. All brew size icons are lit with the default
size flashing. To choose a different size,
press 'LEFT' Button to go down in size or
'RIGHT' Button to go up in size.
5/17/06
®
portion pack, one above
®
portion pack.
®
portion pack.
®
portion pack in the K-Cup
1:06 AM
Page 7
NOTE: The small mug (7.25 oz. serving) is
the factory set default brew size. To program
your favorite brew size see page 11
"Programming Your Brew Size".
b. Your choices are a stronger small cup (5.25
oz. serving), a small mug (7.25 oz. serving),
a large mug (9.25 oz. serving) or a travel
mug (11.25 oz. serving).
c. Once size is chosen, press 'BREW' Button.
BREW Button will stop flashing, LEFT and
RIGHT Buttons will no longer be lit and icon
of brew size will be lit.
NOTE: If you do not push the Brew Button in
60 seconds, the LCD Control Center will
return to 'READY TO BREW' and the Brew
Buttons will be disabled to prevent accidental
activation. Re-activate the Brew sequence by
raising and lowering the Handle completely.
7. The LCD Control Center will now display the
word 'BREWING' and the serving size you
selected will be illuminated on LCD.
CAUTION: There is extremely hot water in
the K-Cup Holder during the brew process.
To avoid risk of injury, do not lift the
Handle or open the K-Cup Chamber
during the brew process.
8. There may be a short pause before the
brewing process begins. The process lasts
about 60 seconds and ends with a burst of
air to remove all liquid coffee or tea from
the K-Cup.
9. Lift the Handle and remove and dispose of the
used K-Cup. CAUTION: K-Cup will be hot.
10.Enjoy your first cup of Keurig Brewed
gourmet coffee or tea!
®
7

Publicité

Chapitres

Table des Matières
loading

Table des Matières