SSS Siedle AHF 870-0 Instructions De Montage page 5

Technische Daten
Versorgung des Gerätes über PoE
(Klasse 2)
Klingellautstärke: max. 83 dB(A)
Farbdisplay: 8,8 cm
Auflösung: 320 x 240 Pixel
Eingang für Etagenruf ERT
(potentialfrei)
Potentialfreier Kontakt:
max. 30 V, 1 A
Abmessungen (mm) B x H x T:
105 x 277 x 23
English
Application
Access handsfree telephone with
speech/control button, door release
button and 7 additional buttons
with 2-colour status LED. All buttons
are freely programmable. The display
shows the graphic menu interface,
but not a camera image. It is pos-
sible to upgrade to a fully functional
video station.
With the functions calling, speech,
door release, light, remote switching
and call barring.
With the additional purchase of the
AUV 870-... F, the AHF 870-... can
be transformed into a fully valid
video indoor device.
Performance features:
• Display 8.8 cm
• Input for storey call
• Output freely programmable
• Call differentiation between door
calls, storey calls, and internal calls
• Switching functions
• Status messages
• Can be used with table-top acces-
sory AZTV 870-... as a table-top
device
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
Electrostatic charging
As a result of electrostatic charging,
direct contact with the circuit board
can result in destruction of the
device. Direct contact with the circuit
board must therefore be avoided.
Scope of supply
• AHF 870-... (Base plate and
housing with circuit board)
• RJ45 plug
• Dummy card for SD card insert
• Operating instructions for the
end user
• This product information
Mounting
1 Recommended mounting height
appr. 1.65 m to display height/
viewing height.
2 Open the device from the back
by releasing the base plate with the
locking lever.
3 Align the base plate centrally rela-
tive to the flush mounted box and
mark the fixing holes.
4 When mounting directly on the
wall, fasten the base plate using
4 screws, paying attention that
the plate is the right way up (top
marking).
5 Hook the housing into the base
plate from above and close by
exerting a slight pressure.
Dismantling
6 To remove the housing, press
the lock upwards using a flat blade
screwdriver. The circuit board
remains in the housing superstruc-
ture.
Lettering
7 The lettering panel can be
inscribed to indicate the button
functions. The see-through panel
can be lifted at the side.
A marking template is provided in
the download area of our website.
Terminal assignment
Left RJ45 socket
1 - 8 LAN
Right RJ45 socket
Storey call button
3, 6
switching contact
4, 5
30 V AC/DC, 1 A
1, 2, 7, 8 dependent on the
Access accessories used
3