MPMan RPS750 Mode D'emploi page 5

Manual Preset
1. Select your wave band and tune to your desired station (See TUNING).
2. Press PROGRAM once to enter programming mode.
3. Press PRESET + or PRESET – to select the desired memory location.
4. Press PROGRAM once again to confirm the selected station.
5. To listen to a preset station:
• select your waveband;
• press the PRESET + or PRESET – for selecting your desired station.
To improve reception:
- For FM, pull out the telescopic aerial. To improve FM Reception incline and turn
the aerial, reduce its length if the FM-signal is too strong (very close to a
transmitter).
Volume
Adjust the sound with the controls VOLUME + or VOLUME -
You may connect headphones with 3.5mm, plug to socket PHONES. The
loudspeaker is then muted.
SPECIFICATIONS
Speaker:
Power Output:
Battery Operate:
AC Operate:
PRECAUTIONS:
1. For AC operation, make sure the voltage is compatible. Always use the
provided AC power cord; never use other AC power cord.
For DC operation, simply insert three "R14 / UM-2 / C" batteries for unit and clock
operation.
2. Always disconnect the AC power cord from the AC power source when it is not
in use or when DC power is operating.
3. Do not leave the batteries in the compartment for a long time. Remove the
batteries to avoid leakage and damage.
4. Do not expose the unit to extreme temperature nor high humidity to ensure
normal functioning for a long lifetime.
3.5 inches, 8 ohm dynamic speaker
0.8W
DC (3 x "R14 / UM-2 / C" 1.5V)
220V ~ 50Hz