MPMan RPS750 Mode D'emploi page 3

OPERATING INSTRUCTION
Battery Supply
Open the battery compartment and insert as indicated in the compartment three
Batteries, type R14, UM2 or C cells.
For Clock backup, insert as indicated in the compartment three Batteries, type
R14, UM2 or C cells.
Mains Supply
If the set is equipped with a 127/220V selector, set this selector to the local mains
voltage.
Connect the mains lead to the wall socket. The mains Supply is switched on.
To disconnect the set from the mains completely, withdraw the mains plug from
the wall socket.
Setting The Clock
1. Check the radio is switched off.
2. Press CLOCK SET for 3 seconds on the front panel to start clock setting.
3. Press PRESET + button for 12-hours/24-hours selection.
4. Press CLOCK SET on the front panel to hour setting.
5. To set the hours, press PRESET + or PRESET - while the display is still
flashing.
6. Press CLOCK SET on the front panel to minute setting.
7. To set the minutes, press PRESET + or PRESET - while the display is still
flashing.
8. Press CLOCK SET on the front panel to complete the clock setting.
The clock needs to be re-set every time when switching DC power to AC
power.
Setting The Alarm
1. Check the radio is switched off.
2. Press ALARM SET for 3 seconds on the front panel to start alarm setting.
3. To set the hours, press PRESET + or PRESET - while the display is still
flashing.
4. Press ALARM SET on the front panel to minute setting.
5. To set the minutes, press PRESET + or PRESET - while the display is still
flashing.
6. Press ALARM SET on the front panel, and press PRESET + or PRESET - to
select the alarm sound as Buzz or Radio.
7. Press ALARM SET on the front panel, and press PRESET + or PRESET - to
select the volume of alarm sound.
8. Press ALARM SET on the front panel to complete the alarm setting.
Remark: Press ALARM SET to enable / disable the alarm function. To make sure
the alarm icon is switch on if alarm function is in using.