Troubleshooting Guide - Heath Zenith Secure Home SH-4150-SV Mode D'emploi

SPECIFICATIONS
Range . . . . . . . . . . Up to 30 ft. (9.1 m)
Sensing Angle . . . . Up to 150°
Electrical Load . . . . U p
Sensor Capacity . . Up to 500 Watt (4.1
Power Requirements .... 120 VAC, 60 Hz
Operating Modes . . T E S T, AU TO, a n d
Time Delay . . . . . . 1, 5, 10 minutes
HeathCo LLC reserves the right to discon-
tinue products and to change specifications
at any time without incurring any obligation
to incorporate new features in products pre-
viously sold.
SYMPTOM POSSIBLE CAUSE
Light will not 1. Light switch is turned off.
come on.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker
4. Daylight turn-off is in effect
5. Incorrect circuit wiring, if this
6. Re-aim the sensor to cover
Light comes on
1. Light control may be installed
in daylight.
2. Light control is in Test. (Set
Light comes on 1. Light control may be sensing
for no apparent
reason.
2. Sensitivity is set too high.
200475-02
[varies with surrounding
temperature].
t o 1 0 0
Maximum Tungsten
Incandescent
A.) Maximum Tungsten
Incandescent
MANUAL MODE

TROUBLESHOOTING GUIDE

is turned off.
(recheck after dark).
is a new installation.
desired area.
in a relatively dark location.
control switch to an ON-TIME
position.)
small animals or automobile
traffic (re-aim sensor).
(Reduce sensitivity.)
W a t t
SYMPTOM
Light stays on
continuously.
Light flashes
on and off.
7
POSSIBLE CAUSE
1. The sensor is pointed toward
a heat source like an air vent,
dryer vent, or brightly-painted
heat-reflective surface.(Re-aim
sensor.)
2. Light control is in Manual Mode.
(Switch to Auto.)
3. Sensitivity is set too high.
(Reduce sensitivity.)
1. Heat being reflected from other
objects may be affecting the
sensor. (Re-aim sensor.)
2. Light control is in the Test
m o d e a n d wa r m i n g u p
(flashing is normal under these
conditions).