Specifications; Care And Maintenance; Reset Button - Heath Zenith secur360 9000 Instructions D'installation Et D'utilisation

Offline Operating Modes
Mode: On-Time
Test
5 Seconds
Auto
1, 5, or 10 Minutes
Accent
3, 6 Hour, To Dawn
Manual
To Dawn*
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
• Motion Sensor (AUTO) – This light fixture is designed
to automatically turn on when the sensor detects a tem-
perature difference moving across the front of the motion
sensor. The light will turn off automatically after a set
amount of time. The ON-TIME control should be set
to 1, 5, or 10 minute setting and the wall switch should
be left in the ON position at all times.
• Optional DualBrite® Control – "DualBrite" mode is a
selectable feature within the app that turns the light on at
a reduced (accent) level at dusk. When motion is detected,
the light will increase to full bright for the amount of the
"Full Brite Setting" (1, 5, or 10 minutes) then returns to
"DualBrite" mode. The light will stay on at the reduced
light level for the amount of time selected (Off, 3 hr., 6
hr., dusk-to-dawn) and then turn off completely. Once
the "DualBrite Time" runs out, the light will turn ON
only when motion is detected. Selecting OFF disables the
"DualBrite" feature, however the motion sensing features
will continue to work.
Motion Sensing Range ......................................Up to 30 ft. (9.1 m) [varies with surrounding temperature]
Motion Sensing Angle ......................................Up to 180°
Electrical Load ..................................................Up to 100 Watt Maximum Incandescent
Bulb Type ..........................................................Medium Base, Type "A", 100 Watt Maximum
Power Requirements ..........................................120 VAC, 60 Hz
Offline Operating Modes ..................................TEST, AUTO, and MANUAL MODE
ON-Timer .........................................................1, 5, 10 minutes (Night Only)
DualBrite Timer ................................................Off, 3, 6 hours, dusk-to dawn (Night Only)
Test Timer .........................................................5 Seconds (Day and Night)
Manual Mode Timer .........................................Dusk-to-Dawn (Night Only)
Works: Day Night
x x
x
x
x
/ minutes for
1
2

SPECIFICATIONS

RESET BUTTON

This light can be reset to the original factory settings either
by using the reset button on the bottom of the sensor or
through the SECUR360 app. Note: After resetting the light,
it may take up to 5 minutes for the light to be removed from
the SECUR360 app.
• Reset Button – Use a paper clip to press the RESET
button for 15 seconds to reset the light.
For additional information concerning this light or the
SECUR360 app , visit www.heath-zenith.com/Secur360.

CARE AND MAINTENANCE

• To prolong the original appearance, clean with clear water
and a soft damp cloth only.
• Do not use paints, solvents, or other chemicals on this
light fixture. They could cause a premature deterioration
of the finish. This is not a defect in the finish and will not
be covered by the warranty.
• Do not spray with hose or power washer.
6 210167-01