Motor-Tube Assembly; Fitting Of The Motor-Tube Assembly; Wiring - SOMFY SGH io Notice Installateur

3.3.

Motor-tube assembly

1) Slide the motor into the roller tube. For smooth roller
tubes, position the cut notch on the crown.
2) For safety reasons, secure the roller tube to the drive
wheel with 4 self-tapping screws with a diameter of 5 mm
or 4 steel pop rivets with a diameter of 4.8 mm located:
- at least 5 mm from the far end of the drive wheel:
L1 - 5, and
- no more than 15 mm from the far end of the drive
wheel: L1 - 15.
The screws or pop rivets must not be fastened on the
motor, but only on the wheel.

3.4. Fitting of the motor-tube assembly

1) Fit the motor-tube assembly to the end bracket (C).
2) Fit the motor-tube assembly to the motor bracket (D).
3) Depending on the type of supports, fit the stopping ring (E)
in place [for the motors 85 Nm, absolutely use the locking
stop ring (F)].
4.

WIRING

Always make a loop on the power supply cable to
prevent water from entering the motor!
- Turn off the mains power supply.
- Connect the motor according to the information provided
in the table below:
230 V ~ 50 Hz
1 Brown Live (P)
2 Blue Neutral (N)
3 Yellow-Green Earth ( )
Copyright © 2010 Somfy SAS. All rights reserved.
Motor cable
1
2
D
3
E
OFF
3 x 0.75 mm
1
230 V
2
~
3
50 Hz
2
3 x 1.5 mm
1
2
3
SGH io
C
F
2
11