Safety; Safety And Responsibility; Specific Safety Advice; Installation - SOMFY SGH io Notice Installateur

SGH io
2.

SAFETY

2.1.

Safety and responsibility

Before installing and using this product, please read this guide carefully.
This Somfy product must be installed by a motorization and home automation professional for whom
this guide is intended.
Moreover, the installer must comply with current standards and legislation in the country in which the
product is being installed, and inform his customers of the operating and maintenance conditions for
the product.
Any use outside the sphere of application defined by Somfy is forbidden. This invalidates the warranty
and discharges Somfy of all liability, as does any failure to comply with the instructions given herein.
Never begin installing without first checking the compatibility of this product with the associated
equipment and accessories.
2.2. Specific safety advice
As well as the safety instructions in this guide, it is also essential to observe the instructions detailed
in attached document "Safety advice to follow and keep".
1) Cut the power supply off corresponding to the roller
shutter before carrying out any maintenance operations
around it.
To prevent damaging the product:
2) Never immerse it in liquid!
3) Avoid impacts!
4) Do not drop it!
5) Never drill holes in it!
6) Do not move the roller shutter when ice has formed on.
3.

INSTALLATION

The SGH io motor installed on the Gradhermetic roller shutter must be installed in a location that
is sheltered from inclement weather.
3.1.

Motor preparation

1) Fit the crown (A) and the drive wheel (B) to the motor.
2) Measure the length (L1) between the inside edge of the
motor head and the end of the drive wheel.

3.2. Tube preparation

1) Cut the roller tube to the required length.
2) Deburr the roller tube and remove the swarf.
3) For smooth roller tubes, cut a notch with the following
measurements:
- e = 4 mm
- h = 28 mm.
10
1
OFF
3
5
1
2
1
3
Copyright © 2010 Somfy SAS. All rights reserved.
2
4
6
B
A
L1 = ...
L1
2
Ø > 47
h
e