Checking The Direction Rotation Of The Motor; Setting The End Limits; Programming Of The First Somfy Io Local Control Point - SOMFY SGH io Notice Installateur

5.3.

Checking the direction rotation of the motor

1) Press the Up button:
a) If the roller shutter is raised, the rotation direction is correct: go to chapter "Setting the end
limits".
b) If the roller shutter is lowered, the direction of rotation is incorrect: press the "my" button until
the roller shutter makes a movement, the direction of rotation has been modified.
2) Press the Up button to check the direction of rotation.
5.4.

Setting the end limits

Setting the lower end limit
1) Set the roller shutter to the lower end limit by pressing
and holding the Down button.
2) Release the button when the desired position is
reached.
3) If necessary, adjust the position of the roller shutter using
the Up or Down buttons.
4) Press the "my" and Up buttons simultaneously: the roller
shutter is raised for 2 seconds.
Setting flat slats
1) Bring the roller shutter into the orientation zone by pressing
and holding the Up button (until the trip mechanism goes
"click") then press the Down button until the "slats flat"
position is reached.
2) Press the Up or Down buttons briefly to adjust the
orientation of the slats so that they are horizontal.
3) Press the Up and Down buttons simultaneously to
validate the horizontal position of the slats: the roller
shutter makes a brief movement.
Setting the upper end limit
1) Place the roller shutter at its lower limit of travel position
by pressing and holding the Down button.
2) Release the button when the desired position is
reached.
3) If necessary, adjust the position of the roller shutter using
the Up or Down buttons.
4) Press the "my" and Down buttons simultaneously: the
roller shutter lowers for 2 seconds.
5) Press and hold the "my" button > 2 seconds, the roller
shutter rises to the upper travel stop: the end limits have
been programmed. Go to chapter "Programming of the
first Somfy io local control point".
5.5. Programming of the first Somfy io local control point
5.5.1. Using pre-programmed Somfy io local control
point
- Briefly press the PROG button on this control point (G):
the roller shutter makes a brief movement; the control
point is programmed.
Copyright © 2010 Somfy SAS. All rights reserved.
1 2
> 2 s.
3 4
1 2
> 2 s.
3
1 2
> 2 s.
3 4
5
Continue to the
> 2 s.
PROG. G
SGH io
2 s.
2 s.
next step
13