Maintenance; Disposal And Recycling; Trouble Shooting - Scheppach OSM100 Traduction Des Instructions D'origine

Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Data of machine type plate
• Data of motor type plate

11. Maintenance

Disconnect the main plug before conducting any
maintenance work.
Cleaning the machine after every use is recommend-
ed.
Keep the safety devices, air boxes and the crank-
case clean.
Clean the machine with a cloth.
Do not use any solvents or cleaning agents because
they could harm the plastic parts of the device.
Do not let water get into the interior of the machine.
The interior of the machine is completely mainte-
nance-free.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: grinding medium, Carbon brushes,
sharpening wheel, angle gauge, v-belt
* Not necessarily included in the scope of delivery!

13. Trouble shooting

Problem Possible Cause
• ON/OFF switch damaged.
• ON/OFF cable damaged.
• ON/OFF relay damaged.
• Fuse blown.
Motor doesn't start
• Motor burnt.
Machine gets slower Too much pressure put on the workpiece.
during work.
The wood gets burnt • Sanding disc or belt covered with grease.
during sanding. • Excessive pressure on workpiece.
• loosely mounted tool
Strong vibrations • defective tool
• spindle knocks
20 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

12. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This product must
be disposed of at a designated collection point.
This can occur, for example, by handing it in at an
authorised collecting point for the recycling of waste
electrical and electronic equipment. Improper han-
dling of waste equipment may have negative conse-
quences for the environment and human health due
to potentially hazardous substances that are often
contained in electrical and electronic equipment. By
properly disposing of this product, you are also con-
tributing to the effective use of natural resources.
You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body
for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Help
• Replace all damaged parts before you use
your machine again.
• Contact your local service centre. Every
attempt to carry out a repair, can be
dangerous if it is not done by skilled
personnel.
Reduce the pressure on the workpiece.
• Replace disc or belt.
• Reduce pressure on workpiece.
• tighten tool
• change tool
• repair at a Service-Station