Product Liability; Product Liability And Intended Use - G-U GU-SECURY Automatic Panik SECURY 19 Notice De Montage

 
Only in case of multi-point locks for single-leaf doors:
Press the latchbolts (with max. 20 N) to test whether they are
properly secured against being pressed back.
 
After the test, you must pull back the latchbolts again by actuating the
lever handle or latch lever (in case of panic function E).
2.

Product liability

According to the German Product Liability Act, which defi nes the liability
of a manufacturer for its products, the following information about lock
systems must be strictly observed.
We as manufacturer will not accept liability for non-observance of this
information.
2.1

Product liability and intended use

The SECURY 19, SECURY 21, and GU-SECURY Automatic Panic multi-
point locks are designed for vertically installed doors. Their main area of
application is building entrance doors in both private and public buildings.
Compliance with the manufacturer's specifi cations, in particular the
instructions in the supplied installation and operating instructions, are a
part of intended use. This is the only way to avoid damage.
Changes made to the multi-point lock without the approval of GU exclude
the manufacturer's liability for resulting damages.
The length of the cylinder fi xing screws must be selected to match the
backset dimension of the lock or cropped to the appropriate length. The
screws of the pre-installed profi le cylinder insert should be used with
preference.
A multi-point lock is a lock which is inserted and screwed into an existing
recess (lock recess) in the door leaf, normally in a swing door system.
23