Using The Electrical Salamander; Prolonged Disuse - LIBRETTO SG-GN 1/1 Serie Installation-Emploi-Entretien

Press the knob down simultaneously with the
piezoelectric unit . Press the knob down for 10-15
seconds and then leave it; the pilot burner will
remain on.
MAIN BURNER IGNITION
To light the main burner, turn the knob from "pilot
on" to "max. flame".
For the minimum flame, turn the knob from "max.
flame" to "min. flame".
TURNING OFF
Turn the knob from "max. flame" or "min. flame"
to "pilot on".
To shut off the pilot, press the knob lightly and turn
it to "off".

11. USING THE ELECTRICAL SALAMANDER

The salamanders are appliances designed for the
cooking and au gratin preparation of foods,
obtained by the radiance emitted by high-
temperature heating elements located over the
food.
The GN 2/3 models are equipped with a single
heating group.
The GN 1/1 models are equipped with two
independent heating elements, making it possible
to use two zones at different temperatures.
The salamanders are appliances for cooking food
and must only be used by professionally qualified
personnel as indicated in this instruction manual.
Any other improper use can be dangerous.
SWITCHING ON AND OFF
The control knob has the following positions:
OFF
MINIMUM TEMPERATURE
INTERMEDIATE TEMPERATURES
MAXIMUM WATER TEMPERATURE
SWITCHING ON
Turn the control knob to the chosen position.
The green indicator light switches on.
TURNING OFF
Turn the knob to position " 0 " .
The green indicator light switches off.
AT THE END OF SERVICE
Switch the heating off.

12. PROLONGED DISUSE

Before any prolonged disuse of the appliance,
proceed as follows:
- Clean the appliance thoroughly.
- Rub stainless steel surfaces with a cloth soaked in
vaseline oil to create a protective film.
- Close cocks or main switches ahead of the
appliances.
19