STEAMAX OSUB BABY SET Manuel D'utilisation page 81

STEAMAX OSUB 80W BABY – ERROR MESSAGES & PROTECTIONS
No Atomizer Head detected ("NO COIL")
The device could not detect a atomizer head. Please install a atomizer head or check that it is properly
connected.
New Atomizer Head ("NEW COIL?")
A (new) atomizer head was detected in temperature mode (TEMP/TC).
Resistance too low ("OHMS TOO LOW")
The resistance of the atomizer head is less than required. Use an atomizer head with a resistance that is above
the required limit for the TC or VW mode. (See „Resistance Range" in the key information & features section)
Resistance too high ("OHMS TOO HIGH")
The resistance of the atomizer head is more than required. Use an atomizer head with a resistance that is below
the required limit for the TC or VW mode. (See „Resistance Range" in the key information & features section)
79
www.steamax.com