Geberit KSS-160 Manuel D'utilisation page 13

Operation
Welding Geberit PE and Geberit
Silent-db20 pipes and fittings
WARNING
Risk of injury from burns
▶ Do not touch the welding plate during
operation or during the cooling-down
phase.
ATTENTION
Risk of injury from burns
▶ Insert the welding plate into the provided stand
during breaks in work.
1
Connect the mains plug to the power supply
system.
5866419979-1 © 12-2018
997.771.00.0 (10)
Geberit welding plate KSS-160/KSS-200:
the red signal lamp lights up during the heat-
up phase. Once the welding temperature
has been reached (after approx. 8 minutes),
the green signal lamp lights up.
Geberit welding plate KSS-315: the heat-up
phase is monitored by the built-in
temperature regulator. The welding
temperature is reached after approx. 20
minutes of heating.
2
Cut the pipes or fittings to length at a right
angle.
Heating the pipes or fittings:
• d 32 mm only by hand.
• d 40–75 mm by hand or with the welding
machine.
• d 90–315 mm only with the welding
machine.
EN
13