Recommended Charge Leads, Polarity; Controls, Using The Charger, Starting The Charge Process - GRAUPNER ULTRA TRIO PLUS 16 Instructions D'utilisation

Liability exclusion
As manufacturers, we at GRAUPNER are not in a position to ensure that you observe the correct
methods of operation when installing, using and maintaining this charger. For this reason we are
obliged to deny all liability for loss, damage or costs which are incurred due to the incompetent or
incorrect use and operation of our products, or which are connected with such operation in any way.
4. Recommended charge leads /polarity
The requirements made on rechargeable batteries vary greatly according to their particular applicati-
on, and this in turn calls for different types of battery connector. Please note that connectors, connec-
tor names and polarities may vary from one manufacturer to another. For this reason we recommend
that you always use genuine matching connectors of identical construction. The following charge
leads are suitable for battery charging with this unit:
Japan
Order No. 3371
Be sure to use genuine charge leads fi tted with cable of adequate conductor cross-section.
5. Charger controls / Using the charger / Starting the process
Cold plug for
100~240V AC cable
(included)
Connectors for
12...15V DC
power supply
or car battery
PC-Interface
Car battery
terminal clips
BALANCER
CONNECTOR for Graupner
battery 1
All the charger's functions are controlled by means of just fi ve buttons.
The - / DEC and + / INC buttons are used to change the current and voltage values, the Output Select
button switches between the charging terminals. The function of the other two buttons varies according
to the presence or otherwise of a battery at the charge sockets:
Operating button
No battery PROGRAMM/MODE
connected: PROGRAMM/MODE 2s.
ENTER/START
Battery PROGRAMM/MODE
connected:
ENTER/START 2 sec.
G2 (AMP/G2,5)
Order No. 3011 Order No. 3037
power output
„BATTERY 1"
+
-
-
Function
Select charge programs and sub-groups
Select the (charge) program group
Select next position of a discharge/cycle adjustment
Ends the charge process, stops the buzzer,
Select next position of a discharge/cycle adjustment
Starts the charge process
BEC
Order No. 3021
Screen
charge output
„BATTERY 2"
Li- BALANCER
CONNECTOR for Graupner
battery 2
JR JR-Sender
Order No. 3022
Operating buttons
charge output
„BATTERY 3"
Li- BALANCER
CONNECTOR for Graupner
battery 3
31