Maintenance - Ego Power+ HTX6500 Guide D'utilisation

MAINTENANCE

WARNING:
other parts may create a hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by EGO authorized dealer/distributor.
WARNING:
injury, always remove the power cord from the product when cleaning or performing
any maintenance.
All hedge trimmer service, other than the items listed in this manual, should be
performed by EGO authorized dealer/distributor.
CLEANING
 Use a soft brush to remove the debris from all air intakes and the cutting blade.
 To remove pitch and other sticky residue, spray the blades with resin solvent. Run
the motor briefly so that the solvent is evenly distributed.
 Wipe the surface with a dry cloth.
WARNING:
cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents. Use a clean cloth to remove dirt, dust, oil, grease, etc.
SHARPENING THE CUTTING BLADE PERIODICALLY
1. Remove the power cord from the hedge trimmer.
2. Disassemble the blade guard from the blades with the supplied hex wrench.
3. For standard steel blade, sharpen the blades with a standard metal file.
NOTICE:
Do not operate your hedge trimmer with dull or damaged cutting blades.This
may cause overload and will give unsatisfactory cutting results.
24
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HTX6500
When servicing, use only identical replacement parts. Use of any
To prevent accidental starting that could cause serious personal
Never use water to clean your trimmer. Avoid using solvents when