Human Touch ht 7120 Mode D'emploi Et D'entretien page 9

care and maintenance
To keep your product working and looking its best, please follow
these simple care guidelines.
Cleaning:
1. Be sure to disconnect the power cord from the electrical outlet before cleaning.
2. Do not use benzene, thinner or any other solvents on your massage chair.
3. Remove dust on the backrest or armrest with a vacuum.
4. If the backrest or armrests become soiled, wipe with a damp cloth, then a dry cloth.
5. Common upholstery cleaners may be used for tough stains.
6. When cleaning the controller or around the power switch, use a dry cloth only. Never use a damp cloth to clean
the controller or power switch.
Fabric Care:
To maintain your Human Touch product in optimum condition, dust it frequently and/or vacuum it with a soft brush vacuum
extension. Faux Suede products can also be brushed with a suede brush. Wipe with a slightly damp cloth as necessary. For
tougher stains on non-leather products, use a mild detergent mixed with water. Leather products should be wiped down
occasionally with a leather furniture cleaning solution.
WARNING:
Be sure to test any cleaning solution on a small, inconspicuous part of the product to ensure that the color does not fade prior
to using the solution on the entire product surface.
humantouch.com
16
Maintenance and Repair:
1. The mechanics of this product are specially designed and constructed to be maintenance free. No periodic lubrication
or servicing is required.
2. Your chair should only be serviced by an authorized service center.
Storage:
1. When not in use for a long period of time, we recommend that the chair be covered, the power cord be coiled and
that the unit be placed in an environment free of dust and moisture.
2. Do not store near heat or open flame. Do not leave this product exposed to direct sunlight for long periods of time.
This may cause fading or damage.
Miscellaneous:
1. Foreign objects should not be inserted between the massage nodes or the unit housing.
2. Care should be taken not to overload the unit.
WARNING:
This product is equipped with a thermal resetting protection device. This is an added safety feature
to protect you and this product from overheating. If the product should suddenly stop and will not start, turn the
main power switch, located on the back of the product, to off and do not operate the product for at least 30 minutes.
Failure to turn the product off may result in the product starting unexpectedly when the product cools.
To replace a fuse:
1. Turn the Power switch to OFF and unplug the chair from the wall outlet.
Fuse
2. Turn the fuse holder (located on the power panel) approximately 1/8 turn
counter-clockwise. The fuse holder pops out.
3. Replace the fuse with a new fuse of the same value, then reinsert the fuse
holder into the power panel.
4. Turn the fuse holder 1/8 turn clockwise to secure it.
5. Plug the chair back into the wall outlet and turn it on.
17