AEG Electrolux PERFECT DB 4050 Mode D'emploi page 14

822 949 208 DB_4050.book Seite 14 Dienstag, 14. Februar 2006 6:46 18
g
Ironing with Steam
To steam iron, set the temperature
selector (Figure 1/N) to the required
fabric type and wait until the power
indicator (Figure 1/J) goes out - only
then set the steam selector(Figure 1/F)
to position "1" (Figure 4/B), "2" or "3" .
You will find which temperature set-
ting (fabric type) matches which steam
setting in the ironing table. As soon as
the iron is held horizontally steam
begins to form. When the iron is set
upright again the steam supply stops
automatically.
Spray Function (Figure 6/A)
The first time you use the appliance,
or if you have not used it for a long
time, you will need to press the spray
function button (Figure 1/H) several
times before water comes out of the
spray nozzle (Figure 1/D). You can also
use the spray function when dry iron-
ing.
Super Steam Jet Function
(Figure 6/B)
The super steam jet function is of
valuable assistance when ironing, for
example, creases, embroidery etc. You
can trigger the additional steam jet
both when steam ironing and when dry
ironing.
0 Set the temperature selector
(Figure 1/N) to the "max." position and
wait until the correct temperature has
been reached, i.e., until the power indi-
cator (Figure 1/J) goes out.
0 Raise the steam iron a little away from
the material and press the steam jet
button (Figure 1/G).
Always wait another 5 seconds before
pressing the steam jet button again.
Steaming hanging items of
clothing
0 Turn the temperature selector
(Figure 1/N) to the "max." position
and wait until the power indicator
(Figure 1/J) goes out.
14
0 Hang the article concerned on a
hanger and hold the steam iron at
a distance of 10 - 20 cm from the
material.
0 Now press the steam jet button
(Figure 1/G). Wait at least 5 seconds
before pressing the button again.
1 Warning: Do not attempt to freshen
up clothing whilst it is still being worn.
Risk of burning!
Storage
Remove the plug from the socket!
Set the temperature selector
(Figure 1/N) to the "Cold" position
(Figure 2/a) and the steam selector
(Figure 1/F) to position "0" (Figure 4/A).
Empty out remaining water (Figure 7).
Store the appliance standing upright.
To store properly wrap the mains cord
around the cord storage (Figures 1/M
and 8).