Operating Instructions; Connecting The Power Cord; Starting/Stopping Instructions - Ryobi RESV1300 Manuel De L'opérateur

CONNECTING THE POWER CORD

Use a minimum 25 foot (7.6 m.) long, 16AWG, outdoor
electrical cord when using this unit. Other sizes include:
MINIMUM WIRE SIZE FOR EXTENSION CORDS FOR
120 VOLT APPLIANCES USING 0-12 AMPS
Cord length (ft.) 25
Wire size (AWG) 16
WARNING:
unit has a polarized plug (one blade is wider
than the other) and will require the use of a
polarized extension cord.
This unit plug will only fit into a polarized extension cord
in one orientation. If the plug does not fully fit into the
extension cord, reverse the plug. If the plug still does not
fit, obtain a correct polarized extension cord.
A polarized extension cord will require the use of a
polarized wall outlet. This plug will only fit into a
polarized wall outlet in a specific orientation. If the plug
does not fit fully into the wall outlet, reverse the plug. If
the plug still does not fit, contact a qualified electrician
to install the proper wall outlet. Do not change the unit
plug, extension cord receptacle, or extension cord plug
in any way.
1. Secure the extension cord to the motor housing as
shown (Fig. 9). This prevents accidental removal of
the electrical cord.

OPERATING INSTRUCTIONS

50 100 150
16 16 14
To reduce the risk of
electrical shock, this
Fig. 9
2. Plug the female end of the electrical cord into the
receptacle at the back of the unit (Fig. 10).
Receptacle
Fig. 10

STARTING/STOPPING INSTRUCTIONS

This unit is equipped with a three-way (OFF/ LOW/
HIGH) switch (Fig. 11):
• Slide the switch all the way down for OFF.
• Slide the switch up to the first click for LOW.
• Slide the switch up to the second click for HIGH.
Once the unit is plugged in, stand in the operating
position (Fig. 12). Slide the power/speed switch to LOW
or HIGH to start the unit. To stop the unit, slide the
switch to OFF (Fig. 11).
Fig. 11
HIGH
LOW
OFF
9