KLIM Ai-1 Manuel D'utilisation page 8

BACK PROTECTOR:
The vest contains a back protector certified
EN 1621-2:2014. The In&motion back protector
has been designed specifically for two-wheeled
motor vehicle users and must be used exclusively
in association with the In&motion airbag system.
INFLATOR REPLACEMENT (O)
Warning! Do not touch the full inflator connector with your
fingers (blue piece on the bottom of the inflator). Do not connect
the inflator connector to the inflator before having screwed it on
the cushion.
1. Replacing the inflator
Warning, inflators are for single-use. After an inflation, it cannot
be refilled and must be changed. Only inflators provided by
In&motion (ref: IMI 2368) are certified and designed for use in
the In&motion airbag system. Do not use any other inflators for
any reason.
To obtain a new inflator, contact your local reseller.
2.Post-inflation procedure
After inflation, please follow the following 4 steps:
1) Check the integrity of the vest
2) Remove the empty inflator
3) Check the integrity of the In&motion airbag system
4) Install a new inflator
These steps are described below. In case of damage or anomaly,
do not use the vest and contact your local reseller.
You will also find this procedure on In&motion tutorial video
available on In&motion Youtube channel:
http://bit.ly/InemotionTuto as well as in the mobile app «My
In&box».
3. Check the integrity of your vest
Check the integrity of the fabric parts and plastic parts.
Check the integrity of the back protector.
Check the integrity of the connector.
If you suspect any deterioration in the vest
(abrasion, holes, rips in the fabrics parts or plastic
parts, breakage or whitening of the plastic parts,
fabric bobbling, rupture of the vest assembly
threads), contact your local reseller.
8 ENGLISH