KLIM Ai-1 Manuel D'utilisation page 5

Gilet airbag
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 68
system to temperatures exceeding this range may compromise
its functionality.
CLEANING INSTRUCTIONS (H)
Do not wet the back protector or the back of your item. The
inflator connector, the inflator, the In&box must not encounter
water. Clean the exterior and interior of your item with soapy
water using a small soft brush and by gently scrubbing in a
circular motion. Then rinse with a soft wet sponge to remove
the excess soap and any dirt that you may have loosened in the
previous step. Dry your item first by using a soft cotton cloth;
then leave to completely air dry in a dry and ventilated area for a
minimum of 12 hours.
• Do not bleach
• Do not iron
• Do not machine wash
• Do not dry clean
• Do not tumble dry
• Do not use a hair dryer
• Do not use detergent
• Dry away from sources of heat and away from sunlight
WARNING (I)
The airbag vest is designed to offer optimal protection only if
the airbag system is inflated.
STORAGE AND TRANSPORTATION (J)
Keep the vest and the In&box in a clean and ventilated area,
away from humidity and light, and away from impacts and
pressure. Do not store the vest and the In&box near combustible
surfaces or objects. Do not leave the vest exposed to direct
sunlight, under a windscreen, store in a car, or in a top case.
Do not fold, crease, bend, twist, or ball up the vest. Hang it on
a hanger or in a completely flat position to avoid any rupture or
breakage.
Transport the vest in clean packaging protecting it from
humidity and direct sunlight.
Make sure to turn your In&box off when using any other
transportation (car, bus, airplane, train or using a motorcycle but
not wearing the airbag system) and keep this user manual for as
long as you have the vest and transfer the user manual to any
subsequent owner of the vest. Furthermore, keep this user
ENGLISH
5

Publicité

Table des Matières
loading

Table des Matières