Lubrication - Campbell Hausfeld XT302000 Instructions D'utilisation

ASSEMBLY
Attaching the tapered-edge sanding pad:
1.
2.
3.
Attach sand paper:
1.
2.
3.
Attach exhaust hose:
1.
2.
3.
4.

LUBRICATION

To protect your tool, lubricate the motor every time—before and after—
you use this tool. You cannot oil the motor too often or put too much oil in
the air inlet.
1.
2.
3.
4.
5.
6.
7.
Turn sander upside down on work surface.
Use the 24 mm wrench to hold the drive
spindle in place while you thread the
6 inch tapered-edge sanding pad. You
must continue to hold the drive spindle
stationery as you tighten the pad.
Once the pad is on tight, you can pull the
wrench out from under the sanding pad
collar. You may have to jiggle it a little to
remove it.
Ensure sandpaper disc is 6 inch with 6-holes
and pressure-sensitive adhesive backed.
Peel the release liner and align paper over tapered-edge sanding pad;
make sure the vacuum holes from paper to pad line up.
Press firming over entire surface of pad.
Twist exhaust hose into exhaust hose port until hose is firmly attached.
Unfold exhaust dust bag and insert other end of exhaust hose in the bag
at the string end.
Wrap strings around hose and tie securely in a bow.
Note other end of exhaust dust bag is sealed with a hook & loop closure
for easier emptying.
Disconnect the random orbit palm sander from air supply.
Turn the sander on end so that the air outlet is facing up.
While pulling the trigger, pour approximately a teaspoon of air tool oil
in the air inlet. Campbell Hausfeld makes an air tool oil under model
number ST1270.
Release the trigger and connect the tool to the air supply and cover the
exhaust port with a towel.
Trigger the sander wrench for 20 to 30 seconds. Oil will spray from the
exhaust port when the tool is triggered.
Continue to run until no oil is discharged.
Wipe all residual oil from tool before use.
4