Set Up Instructions - Campbell Hausfeld XT302000 Instructions D'utilisation

GETTING TO KNOW YOUR UNIT
Tapered-edge
Sanding Pad

SET UP INSTRUCTIONS

Exhaust dust bag
* Items shown in Set Up Instructions are not included with this tool.
◆ The air compressor used with your random orbit palm sander must be able to
maintain a minimum of 90 PSI when the tool is being used. An inadequate air
supply can cause a loss of power and inconsistent tool output/performance.
◆ A pressure regulator—used at the tool--is helpful to control the operating pressure
of the tool and maintain 90 PSI.
◆ Use an oiler to provide oil circulation through the tool and a filter to remove liquid
and solid impurities which can rust or "gum up" internal parts of the tool.
◆ To disconnect a coupler/plug from a system set-up: push the coupler and plug
together before pulling the coupler sleeve back and separating the coupler and
plug.
Sanding Pad Collar
Drive Spindle
24MM Spindle
Air Hose
BEST PRACTICES
Trigger
Air Inlet
Air-flow
Regulator
Tab
Wrench
Quick
Coupler
Exhaust hose
3
Vacuum Attachment
(Exhaust Port)
Exhaust Dust
Bag
Plug
Exhaust Hose
Sand Paper
Disc