Campbell Hausfeld XT302000 Instructions D'utilisation page 10

SAFETY INSTRUCTIONS (CONTINUED)
18. Ensure sandpaper is fully sealed onto sanding pad and that pad is
19. Do not free spin tool. Acuate trigger just before engaging work surface
work motions can cause injury to hands and arms. Stop using any tool if
discomfort, numbness, tingling, or pain occur, and consult a physician.
port during the first few seconds of operation after an airtool has been
lubricated. Failure to cover exhaust port can result in serious injury.
Safety Glossary
This manual contains information that is very important to know and
understand. This information is provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help recognize this information, observe the
following symbols.
IMPORTANT or NOTE: Information that requires special attention.
Safety Symbols
The following Safety Symbols appear throughout this manual to alert you to
important safety hazards and precautions.
Wear Eye
and Mask
Protection
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
securely tightened to tool spindle.
and release trigger when lifting tool away from surface.
MANUAL
Read Manual
First
Do not misuse this product. Excessive exposure to
vibration, work in awkward positions, and repetitive
This air tool requires lubrication before initial use
and before and after each additional use.
Cover exhaust port with a towel before applying
air pressure. Oil will discharge through the exhaust
Danger indicates an imminently hazardous situation
which, if not avoided, WILL result in death or serious
injury.
Warning indicates a potentially hazardous situation
which, if not avoided, COULD result in death or
serious injury.
Caution indicates a potentially hazardous situation
which, if not avoided, MAY result in minor or
moderate injury.
Notice indicates important information, that if not
followed, may cause damage to equipment.
Risk of Wear Eye
Explosion and Hearing
Protection
8
Risk of Risk of Fumes
Pressure