Campbell Hausfeld XT302000 Instructions D'utilisation page 12

GENERAL TROUBLESHOOTING GUIDE
SYMPTOM
Tool runs slowly, will
not operate or has low
power
Moisture blowing out
of tool
POSSIBLE CAUSE(S)
1. Grit or gum in tool
2. No oil in tool
3. Low air pressure
4. Air hose leaks
5. Pressure drops
6. Speed adjustment set too
low
7. Worn or broken rotor vanes
1. Water in tank
2. Water in the air lines/hoses
CORRECTIVE ACTION
1. Flush the tool with Campbell
Hausfeld air tool oil, gum solvent, or
an equal mixture of SAE 10 motor
oil and kerosene. Lubricate the
tool after cleaning with Campbell
Hausfeld (or comparable) air tool oil.
2. Lubricate the tool according to
the lubrication instructions in this
manual.
3. a. Push speed adjustment lever on
tool to higher setting.
b. Adjust compressor regulator to
90 PSI while tool is running free.
4. Tighten and seal hose fittings, if leaks
are found.
5. a. Be sure the hose is the proper
size. Long hoses or tools using
large volumes of air may require
a hose with an I.D. of 1/2 inch or
larger depending on the total
length of the hose.
b. Do not use a multiple number of
hoses connected together with
quick connect fittings. This causes
additional pressure drops and
reduces the tool power. Directly
connect the hoses together.
6. Push speed adjustment to higher
setting.
7. Replace tool.
1. Drain tank. (See air compressor
manual). Oil tool and run until no
water is evident. Oil tool again and
run 1-2 seconds.
2. a. Install a water separator/filter.
NOTE: Separators only work
properly when the air passing
through the separator is cool.
Locate the separator/filter as far
as possible from the compressor.
b. Install an air dryer.
c. Oil tool immediately anytime
water enters tool.
10