General Safety - Campbell Hausfeld XT302000 Instructions D'utilisation

General Safety

This product is a part of a high pressure system and the following safety
precautions must be followed at all times along with any other existing safety
rules.
1. Read all manuals included with this product carefully. Be thoroughly
familiar with the controls and the proper use of the equipment.
MANUAL
2. Only persons well acquainted with these rules of safe operation should
be allowed to use the air tool.
in death or serious personal injury.
3. Do not exceed any pressure rating of any component in the system.
4. Disconnect the air tool from air supply before changing tools or
attachments, servicing and during non-operation.
5. Do not wear loose fitting clothing, scarves, or neck ties. Loose clothing
may become caught in moving parts and result in serious personal injury.
6. Do not wear jewelry when operating any tool. Jewelry may become
caught in moving parts and result in serious personal injury.
7. Do not depress trigger when connecting the air supply hose.
8. Always use attachments designed for use with air powered tools. Do not
use damaged or worn attachments.
9. Never trigger the tool when not applied to a work object. Attachments
must be securely attached. Loose attachments can cause serious injury.
10. Protect air lines from damage or puncture. Do not carry tool by the air
hose.
11. Never point an air tool at oneself or any other person. Serious injury
could occur.
12. Check air hoses for weak or worn condition before each use. Make sure
all connections are secure.
13. Keep all nuts, bolts and screws tight and ensure equipment is in safe
working condition.
14. Do not put hands near or under moving parts.
15. Always secure work piece. Use a clamp if necessary.
16. Always work in a well ventilated area and wear OSHA approved dust
mask.
17. Use only sanding pads rated at or above the tool's RPM.
during use and cause serious injury.
Do not exceed maximum operating pressure of the
air tool (90 PSI). The air tool could explode and result
Safety glasses and ear protection must be worn
during operation.
Release all pressure from the system before
attempting to install, service, relocate or perform
any maintenance.
Check sanding pad for cracks and wear prior to use.
Replace if damaged. A damaged pad can break apart
7