Lubrication - Campbell Hausfeld CL1565 Mode D'emploi

Operating Instructions
Assembly (Continued)
Do not use
hoses or fi ttings
that are damaged or deteriorated.
Never carry a tool
by the hose or
pull the hose to move the tool or a
compressor. Keep hoses away from
heat, oil and sharp edges. Replace any
hose that is damaged, weak or worn.
AIR TOOL SETUP - ALL MODELS
1. Ensure tool is not connected to air
supply then place tool upside down
on workbench.
2. Position supplied wrench on
hexagonal spindle and hold in place
(See Figure 2).
3. Make sure spacer is in place on
threaded stud of sanding pad (See
Figure 2) then hand tighten pad to
spindle by turning clockwise. Remove
wrench.
NOTE: Use only genuine Campbell
Hausfeld sanding pads of the same type,
size and weight.
Spacer
Figure 2 - Sanding pad assembly
SANDPAPER APPLICATION
1. Ensure sandpaper is the correct size
and type for the sanding pad used.
2. Peel release liner from back of
sandpaper (if using pressure sensitive
adhesive (PSA) backed paper).
4
3. Align paper over sanding pad then
press firmly over entire surface of
sanding pad.
Pre-Operation

LUBRICATION

Air tools require lubrication throughout
the life of the tool and is the owner's
responsibility. Failure to lubricate the air
tool properly will dramatically shorten the
life of the tool and will void the warranty.
BEFORE the initial use and BEFORE and
AFTER each additional use.
AUTOMATIC LUBRICATION
The recommended method for
lubrication is with an air line lubricator
installed as part of the air piping system.
See Figure 1. Use Campbell Hausfeld air
tool oil ST127001AV or equivalent ISO
grade 32 oil.
MANUAL LUBRICATION
If an air line lubricator is not used, the
tool must be lubricated daily.
Spindle
supply before lubricating.
1. Disconnect the air tool from the air
supply.
2. Turn the air tool upside down.
3. While pulling the trigger, squeeze
approximately a 1/4 oz. of Campbell
Hausfeld airtool oil in the air inlet. If
applicable, switch the forward and
reverse valve in both directions.
lubricated, oil will discharge through
the exhaust port during the fi rst few
seconds of operation. The exhaust port
must be directed away from your body
before applying air pressure.
www.campbellhausfeld.com
This air tool
requires lubrication
Disconnect the
air tool from the air
After an air tool
has been