Télécharger Imprimer la page

Specifications; Operation; Battery Information - Sunoptic Surgical LIT102 Manuel D'instructions

Led rover

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4. SPECIFICATIONS

Item
Lamp Type
Color temperature
Lamp life
Battery
Current converter output
Discharge time
Model
Dimensions
Weight
Electrical Protection
Medical Classification

5. OPERATION

The LED Rover is operated by a pushbutton switch inside a protective silicone rubber boot
at the back end of the handle. It features a momentary ON function with partial depression
of the switch, and clicks to stay ON with full depression. Depress the switch fully again to
turn it off.
6.

BATTERY INFORMATION

6.1 DISPOSABLE BATTERY MODEL
BATTERY REPLACEMENT
Unscrew the headpiece that houses the LED. (Do not remove the switch; the batteries
cannot fit through the switch end.) Remove the old batteries and insert the new ones.
Observe correct polarity. The positive (+) end of both batteries must point toward the
headpiece. The positive end of the battery has a protruding nipple, the negative (-)
end is flat.
NOTE: Because discharge characteristics may vary between designations or
between used and unused batteries, always replace batteries in pairs with pairs
of identical new batteries.
Replace disposable 3 volt Lithium CR123 primary batteries only with similar size and
voltage batteries.
Storage: Store in a dry area at 40º F – 85º F.
LIT102 SUNOPTIC SURGICAL
(English)
Specification
LED
6500° K (nominal)
50,000 hrs. (nominal)
Lithium CR123, 3Volts (2X) or Lithium Ion RCR123A 3V
(2X)
611 milliamps (nominal)
110 minutes (typical, actual endurance may vary)
LED Rover
5.1 inches long X 1.25 inches diameter at LED housing
3.7 oz.
Class I, Type BF
FDA Class II
Europe Class I
®
Rev. O
Date of Revision:11/11/15
Page 5 of 40

Publicité

loading