CLAS OC 0350 Mode D'emploi page 15

OC 0350
INDUCTION DENT REMOVAL
INTRODUCTION
Our OC 0350 induction dent removal unit is a small, portable, multi-functional heating unit
consisting of an inverter and an accessory. The device can be remotely controlled by a
connector on the front panel, allowing it to be integrated into the automatic production
process or used as a laboratory instrument. In this case, it is necessary to use special heating
inductors for remote control or automatic operation.
CAUTION: Do not attempt to place (or use) the equipment until you are familiar with the
full operating instructions. Keep this manual for future use.
SAFETY
1. General rules for using the OC 0350
The symbols in this manual warn and identify potential dangers when handling the unit.
• Do not leave the unit unattended while it is on. Always switch it off with the main switch
when you are not using it!
• Make sure that the air supply to the power supply unit is sufficient for cooling.
• Make sure that the ventilation openings are clean and free of dust and dirt, so as not to
prevent the flow of cooling air.
• Do not attempt to repair your OC 0350. there are no user-serviceable components inside
the unit.
• The user is responsible for installing and operating the system in accordance with the
instructions in this manual. The supplier is not liable for damage resulting from improper
use and operation.
• Only persons over 15 years of age, properly trained and qualified may use the equipment.
Do not use the equipment under the influence of drugs, alcohol or medication.
• Keep people and animals at a safe distance when working with the device, including when
the device cools down.
• Avoid working in rain, water and humid environments. Keep the work area well ventilated
and dry, clean and well lit.