Siemens TE607F Serie Mode D'emploi page 50

en
The line at the bottom of the display
indicates the progress of the descaling
process�
F If there is a water filter in the water
tank 5, be sure to remove it before
starting the service programme�
● Touch A to open the menu�
● Use I to choose Cleaning and care
and touch B to confirm your choice.
● Use I to choose calc'nClean and
touch B to confirm your choice.
● Touch C to begin running the
programme�
The display 3 will indicate the progress of
the programme:
● Empty and re-insert the drip tray 17�
● Place a container with a capacity of 1 litre
under the beverage outlet 4�
● Place the end of the suction pipe 4d in
the container�
● Touch C�
● Open the ground coffee drawer 12�
● Drop one Siemens cleaning tablet in the
drawer 12 and close it�
● Touch C�
The following request appears:
F
Remove water filter if inserted ¢start�
● Remove the filter and then touch
C again�
● Pour lukewarm water into the empty water
tank 5 up to the "0.5 l" mark and then
dissolve one Siemens descaling tablet
TZ80002 in it� For the TZ60002 you
should always dissolve two tablets�
● Touch C�
The descaling programme will now run for
about 28 minutes�
F If there is not enough descaling solu-
tion in the water tank 5, you will see
the prompt Refill descaler ¢start�
● Add more descaling solution and then
touch C again�
46
● Rinse the water tank 5 and refill it with
fresh water up to the "max" mark�
● Touch C�
The descaling programme will now run
for about one more minute, and then the
cleaning programme will run for about
7 minutes and rinse the appliance�
● Empty and re-insert the drip tray 17�
Important: Wipe over the appliance
F
with a soft damp cloth to ensure that
you immediately remove any traces
of descaling solution� It is possible
for corrosion to form underneath
such deposits� New sponge cloths
may contain salts that can cause
rust films to form on stainless steel,
so such cloths should always be
thoroughly rinsed before use� Clean
the suction pipe 4d of the drinks
outlet particularly carefully�
● If you use a filter, replace it now.
The appliance has finished descaling and is
ready for use again�
Important: If any of the service
F
programmes is ever interrupted, for
instance by a power failure, please
proceed as follows:
● Rinse the water tank 5 and refill it with
fresh water up to the "max" mark�
● Touch C�
The appliance will be rinsed for approx�
2 minutes for safety reasons�
● Empty and re-insert the drip tray 17�
The aborted service programme must
be restarted�