Allmand PORT-A-LITE PAL50 Single LED Manuel D'utilisation page 8

The LED fixture may be rotated left / right, and up /
down.
3. Raise the mast to the desired height.
1. Pull the latch spring pin and rotate it 90°.
2. Raise the inner mast to the desired height. There are
four holes in the inner mast that may be used.
3. Rotate the latch spring pin 90° and engage one of
the four holes in the inner mast. Be sure the latch
spring pin is fully seated in the hole.
4. Connect the power cord and turn on the work light.
1. Connect the power cord to a wall outlet or power
generator.
Note: If an extension cord is required, use an extension
cord rated for the current required by the work light.
See Specifications for detailed information on power
requirements.
2. Move the power switch to the ON position.
To Shut Down The Unit
8
1. Shut off the work light and disconnect the power
cord.
1. Move the power switch to the Off position.
2. Disconnect the power cord from the wall outlet or
power generator.
2. Lower the mast.
1. Hold the inner mast, then pull the latch spring pin
and rotate it 90°.
2. Fully lower the inner mast.
3. Rotate the latch spring pin 90° and engage the hole
in the inner mast. Be sure the latch spring pin is fully
seated in the hole.
Maintenance