Operating The Unit - Allmand PORT-A-LITE PAL50 Single LED Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

 Overhead Obstructions 
Always keep well clear of any overhead power wires. Make
sure there are no overhead obstructions where you intend to
place the portable work light. Keep clear of any loose cables,
ropes or obstructions that could ensnare the mast or LED
fixture. When the mast is fully elevated, the portable work
light stands 9.6 feet (2.9 m) from ground level to the top of the
LED fixture. 
DANGER
 Electrocution Hazard. 
Contact with overhead electrical wires will result in death
or serious injury. Always follow the rules or instructions for
your work site, and the state, province and federal rules for
maintaining a safe distance from overhead wires. 
 Wetness & Wind 
The portable work light must be placed on a dry surface away
from areas that might become wet. 
WARNING
 Shock Hazard. 
Positioning a portable work light on a wet surface or in
water will result in death or serious injury. Always position
the work light on a dry surface away from areas where
water may flow or accumulate. 
Do not set up the work light in an area where winds exceed
10 mph (16 km/h). 
WARNING
 Unsafe Operation Hazard. 
Operating the portable work light with the mast fully
elevated in winds exceeding 10 mph (16 km/h) can cause
work light tip over resulting in death or serious injury.
Always fully lower the mast when winds are expected to
exceed 10 mph (16 km/h). 
 Work Surface 
The portable work light must be placed on a firm, stable
surface capable of supporting the total weight of the work
light. The surface should be level, and must not exceed a
grade of 5% (2.8° incline) in any direction. 
WARNING
 Rollover / Tipover Hazard. 
Positioning the portable work light on soft or unstable
ground could cause work light rollover resulting in death or
serious injury. Always position the work light on a firm, level
and stable surface. 

Operating The Unit

To Operate The Unit
 
 
1.  Connect the LED fixture.  
 
 Loosen the cable tie. Connect the base cable to the
fixture cable. 
2.   Position the LED fixture. 
 
7

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Port-a-lite pal60 single led

Table des Matières