Preparing For Set-Up; Set-Up Instructions - Allmand PORT-A-LITE PAL50 Single LED Manuel D'utilisation

® ®
The Allmand Port-A-Lite
lights require an external power source and may be plugged
into a wall outlet or portable generator.
Identify the features and controls of the machine by
comparing Figure 2 with the table following.
2
Ref
A LED Light Fixture
B Fixture Yoke
C Fixture Handle Nut (Locking Pin on some models)
PAL Single LED portable work
Description
Ref
D Fixture Cable
E Inner Mast
F Latch Spring Pin
G Outer Mast
H Base Cable
I Power Cord
J Cable Tie
K Mast Socket Knob
L Base Assembly
M Power Switch
Set-Up

Preparing For Set-Up

® ®
Allmand Port-A-Lite PAL LED portable work lights are
shipped in separate cartons, and require assembly before
use. Upon receiving the unit, remove each piece from
the shipping cartons and inspect the parts for damage.
Contact your dealer or Allmand if parts were damaged during
shipping.

Set-Up Instructions

1. Loosen the mast socket knob (A, Figure 3).
2. Insert the outer mast (B, Figure 3) in the socket, and
tighten the knob.
3. Make sure the inner mast (C, Figure 3) is completely
lowered, and that the latch spring pin (D) is engaged in
the hole in the inner mast.
4. Place the center hole of the fixture yoke (E, Figure 3)
onto the stud on the inner mast, and secure with the
plastic washer (F), flat washer (G) and jam nut (H). Do
not overtighten.
5. Remove the cable tie (I, Figure 3) from the base cable (J).
6. Connect the base cable to the fixture cable (K, Figure 3).
Description
5